www.elektronik.si

[puscasvictor]

Idea was taken from Cyfrowa stacja lutownicza,Kamil Szkutnik. Important should have controlled temperature and be powered by 24V not 230V.Soldering station controlled by Mikrocontroller ATMEGA8, zero phase detection crosing and MOC-3041.
Advantage low cost,program written in Bascom. Seting temperature there three buttons and temperature adjustment step is 10 celsius degrees(28-350)
The display enables viewing 2x16 marks.Important remember to press buttons UP and DOWN,at the same time to set 250 celsius degrees(after that with the soldering station is available)
Spoznal sem(zgradili smo)digitalno spajkalno postajo z ATMEGA8.Jaz sem zadovoljna z njo. Tam sem govoril slovenski jezik.
Iz spostovanja do vas, sem poskusil,kako lahko.Navdihnil me je kolega poljski.Ne vem,kako dobro ona prevod.Trudim se in anglescina
Roeka 24v/48W.Senzor za temperatero se nahaja v roeki.Semzorji za toploto tip K.
Temperatura nastavljena=temperature spodaj izmerjeni+/- 9 degree celsius

[puscasvictor]

[MadMax]

It's better that you write in English, we will probably understand more than GoogleTranslated text
Except if you want to learn Slovenian?

[puscasvictor]

[puscasvictor]

Excuse me,MadMax.
Zelim izvedeti slovasko(SLOVENA)
I am sorry. Sledi in drugi dodatki, PROGRAM BASCOM, HEX...

[MadMax]

I don't really understand... You want to learn "slovasko" (Slovakia, half of ex-Czechoslovakia) ?
Well, in that case I have to dissapoint you: this is slovenian forum, not slovakian...
Slovakia wiki (original Slovenská republika)
Slovenia wiki (original Republika Slovenija)
Sometimes dificult to know the difference...

Anyway, good job, excellent project you made!

[puscasvictor]

[puscasvictor]

[puscasvictor]

V samo roeko je vgrajen termoelement K.Roeka ima 5 pin speljanih do postaje.V dveh je napajanje 24V, v dveh signal za temperaturo v peti pa je ozemljitev-PENSOL SOLOMON 24V/48w.
P=UXI=48W=24VxI
I=2A current

[puscasvictor]

SLOVENIJA(LIUBLIANA) je lepa dezela zlepimi ljudmi in delaven.

[kose19]

Welcome to forum Victor.
I'm intresting to this project. I have plan to do this for two years, but not started yet.

[puscasvictor]

Konstruckje.....

[puscasvictor]

Kose19:
Thank you so much. Many thanks. Can I help You? Is there anything I can do for you?
I so novi.Zacetnik! Jaz zmorem tezko

[puscasvictor]

Slika je vredna tisoc besed....Faze..gradnje

[puscasvictor]

Hex Bascom